Electrical Circuits

electrical-circuits

Exit

Question 1 of 1

Time Left

6613

block

The resistance of a copper wire to the flow of electricity___ as the _ of the wire ______.

Select the correct answer(s).

(0/0)

6614

none

Operating an incadescent electric light bulb at less than its rated voltage will result in

Select the correct answer(s).

(0/0)

6615

none

An interlock is generally installed on electronic equipment to

Select the correct answer(s).

(0/0)

6616

none

A flame should not be used to inspect the electrolyte level in a lead-acid battery because the battery cells give off highly flammable

Select the correct answer(s).

(0/0)

6617

none

The amperage rating of the fuse to be used in an electrical circuit is determined by the

Select the correct answer(s).

(0/0)

6618

none

In a 208 volt, three phase, 4 wire circuit, the voltage, in volts, from any line to the grounded neutral is APPROXIMATELY

Select the correct answer(s).

(0/0)

6619

none

Where conduit enters a knock-out in an outlet box, it should be provided with a

Select the correct answer(s).

(0/0)

6620

none

The electic circuit to a ten kilowatt electric hot water heater which is automatically controlled by an aquastat will also require a

Select the correct answer(s).

(0/0)

6621

none

The material which is LEAST likely to be found in use as the outer covering of rubber insulated wires or cables is

Select the correct answer(s).

(0/0)

6622

none

In measuring to determine the size of a stranded insulated conductor, the PROPER place to use the wire gauge is on

Select the correct answer(s).

(0/0)

6623

none

Rubber insulation on a electrical conductor would MOST quickly be damaged by continuous contact with

Select the correct answer(s).

(0/0)

6624

none

In a two wire electrical system, the color of the wire which is grounded is USUALLY

Select the correct answer(s).

(0/0)

6625

none

The one of the following that is NOT part of an electric motor is a

Select the correct answer(s).

(0/0)

6626

none

The power factor in an AC circuit is on when

Select the correct answer(s).

(0/0)

6627

none

The ordinary single-pole flush wall type switch must be connected

Select the correct answer(s).

(0/0)

Results

Correct

0 Incorrect

0 Skipped

0 Overall Percentage

0%

Saving quiz

Save Score

Rate Quiz

Save Rating

Exit

Electrical Circuits

Question 1 of 1

Time Left

The resistance of a copper wire to the flow of electricity_______ as the _______ of the wire ________.

Select the correct answer(s).

(0/0)

Operating an incadescent electric light bulb at less than its rated voltage will result in

Select the correct answer(s).

(0/0)

An interlock is generally installed on electronic equipment to

Select the correct answer(s).

(0/0)

A flame should not be used to inspect the electrolyte level in a lead-acid battery because the battery cells give off highly flammable

Select the correct answer(s).

(0/0)

The amperage rating of the fuse to be used in an electrical circuit is determined by the

Select the correct answer(s).

(0/0)

In a 208 volt, three phase, 4 wire circuit, the voltage, in volts, from any line to the grounded neutral is APPROXIMATELY

Select the correct answer(s).

(0/0)

Where conduit enters a knock-out in an outlet box, it should be provided with a

Select the correct answer(s).

(0/0)

The electic circuit to a ten kilowatt electric hot water heater which is automatically controlled by an aquastat will also require a

Select the correct answer(s).

(0/0)

The material which is LEAST likely to be found in use as the outer covering of rubber insulated wires or cables is

Select the correct answer(s).

(0/0)

In measuring to determine the size of a stranded insulated conductor, the PROPER place to use the wire gauge is on

Select the correct answer(s).

(0/0)

Rubber insulation on a electrical conductor would MOST quickly be damaged by continuous contact with

Select the correct answer(s).

(0/0)

In a two wire electrical system, the color of the wire which is grounded is USUALLY

Select the correct answer(s).

(0/0)

The one of the following that is NOT part of an electric motor is a

Select the correct answer(s).

(0/0)

The power factor in an AC circuit is on when

Select the correct answer(s).

(0/0)

The ordinary single-pole flush wall type switch must be connected

Select the correct answer(s).

(0/0)

Results

Correct

0

Incorrect

0

Skipped

0

Overall Percentage

0%

Rate Quiz

The resistance of a copper wire to the flow of electricity___ as the _ of the wire ______.