Chapter 4.2 (100-119)

chapter-4-100-119

Exit

Question 1 of 1

Time Left

372799

180

block

(Refer to figure 27, Area 2.) The day VER visibility and cloud clearance requirements to operate over the town of Cooperstown, after departing and climbing out of the Cooperstown Airport at or below 700 feet AGI are

Select the correct answer(s).

(0/0)

Explanation

This area is inside a magenta shaded ring meaning that Class E airspace begins at 700 feet AOL Below 700 feet AOL, the minimums for Class G airspace apply.

372800

180

none

Unless otherwise specified. Federal Airways include that Class E airspace extending upward from

Select the correct answer(s).

(0/0)

Explanation

Federal Airways normally begin at 1,200 feet AGL and extend up to, but not including, 18,000 feet MSL.

372801

180

none

The width of a Federal Airway from either side of the centerline is

Select the correct answer(s).

(0/0)

Explanation

A Federal Airway is normally 8 NM wide (4 NM each side of the centerline).

372802

180

none

Normal VFR operations in Class D airspace with an operating control tower require the ceiling and visibility to be at least

Select the correct answer(s).

(0/0)

Explanation

In order to operate in Class D airspace, the VFR visibility minimum is three statue miles. In addition, the ceiling must be at least 1,000 feet.

372803

180

none

At what altitude shall the altimeter be set to 29.92, when climbing to cruising flight level?

Select the correct answer(s).

(0/0)

Explanation

To standardize altimeter settings in Class A airspace, all pilots are required to set their altimeters to 29.92 at and above 18,000 feet MSL.

372804

180

none

A blue segmented circle on a Sectional Chart depicts which class airspace?

Select the correct answer(s).

(0/0)

Explanation

Class D airspace is designated on sectional charts by a blue segmented circle. Class B airspace is indicated by a solid blue line. Class C airspace is designated by a solid magenta line.

372805

180

none

Airspace at an airport with a part-time control tower is classified as Class D airspace only

Select the correct answer(s).

(0/0)

Explanation

In order for airspace to be classified as Class D there must be an operating control tower.

372806

180

none

Unless otherwise authorized, two-way radio communications with Air Traffic Control are required for landings or takeoffs.

Select the correct answer(s).

(0/0)

Explanation

When operating at an airport where a control tower is in operation, you must be in radio contact with ATC whether or not VFR conditions exist.

372807

180

none

Two-way radio communication must be established with the Air Traffic Control facility having jurisdiction over the area prior to entering which class airspace?

Select the correct answer(s).

(0/0)

Explanation

You must establish two-way communications prior to entering a Class C airspace area, and maintain it while operating within the Class C airspace.

372808

180

none

What minimum radio equipment is required for operation within Class airspace?

Select the correct answer(s).

(0/0)

Explanation

To operate in a Class C airspace area, you are required to have both a two-way radio and a 4096-code transponder with encoding altimeter.

372809

180

none

What minimum pilot certification is required for operation within Class B airspace?

Select the correct answer(s).

(0/0)

Explanation

To operate in a Class B airspace area, a pilot must hold a private pilot certificate. However, within certain Class B airspace areas, student pilot operations may be conducted after receiving specific training and a logbook endorsement from an authorized

372810

180

none

What minimum pilot certification is required for operation within Class B airspace?

Select the correct answer(s).

(0/0)

Explanation

372811

180

none

What minimum radio equipment is required for VFR operation within Class B airspace?

Select the correct answer(s).

(0/0)

Explanation

VFR operations within Class B airspace areas require a two-way radio and a 4096-code transponder with an encoding altimeter.

372812

180

none

An operable 4096-code transponder and Mode C encoding altimeter are required in

Select the correct answer(s).

(0/0)

Explanation

A 4096-code transponder with an encoding altimeter is required for operations within a Class B airspace area. It is not required in Class D airspace or Class E airspace below 10,000 feet MSL.

372813

180

none

In which type of airspace are VFR flights prohibited?

Select the correct answer(s).

(0/0)

Explanation

Only IFR operations are allowed in Class A airspace. VFR flights are allowed in Class B and C airspace if authorized by ATC.

Chapter 4.2 (100-119)

Question 1 of 1

Time Left

(Refer to figure 27, Area 2.) The day VER visibility and cloud clearance requirements to operate over the town of Cooperstown, after departing and climbing out of the Cooperstown Airport at or below 700 feet AGI are

Select the correct answer(s).

(0/0)

Explanation

Unless otherwise specified. Federal Airways include that Class E airspace extending upward from

Select the correct answer(s).

(0/0)

Explanation

The width of a Federal Airway from either side of the centerline is

Select the correct answer(s).

(0/0)

Explanation

Normal VFR operations in Class D airspace with an operating control tower require the ceiling and visibility to be at least

Select the correct answer(s).

(0/0)

Explanation

At what altitude shall the altimeter be set to 29.92, when climbing to cruising flight level?

Select the correct answer(s).

(0/0)

Explanation

A blue segmented circle on a Sectional Chart depicts which class airspace?

Select the correct answer(s).

(0/0)

Explanation

Airspace at an airport with a part-time control tower is classified as Class D airspace only

Select the correct answer(s).

(0/0)

Explanation

Unless otherwise authorized, two-way radio communications with Air Traffic Control are required for landings or takeoffs.

Select the correct answer(s).

(0/0)

Explanation

Two-way radio communication must be established with the Air Traffic Control facility having jurisdiction over the area prior to entering which class airspace?

Select the correct answer(s).

(0/0)

Explanation

What minimum radio equipment is required for operation within Class airspace?

Select the correct answer(s).

(0/0)

Explanation

What minimum pilot certification is required for operation within Class B airspace?

Select the correct answer(s).

(0/0)

Explanation

What minimum pilot certification is required for operation within Class B airspace?

Select the correct answer(s).

(0/0)

Explanation

What minimum radio equipment is required for VFR operation within Class B airspace?

Select the correct answer(s).

(0/0)

Explanation

An operable 4096-code transponder and Mode C encoding altimeter are required in

Select the correct answer(s).

(0/0)

Explanation

In which type of airspace are VFR flights prohibited?

Select the correct answer(s).

(0/0)

Explanation

Results

Correct

0

Incorrect

0

Skipped

0

Overall Percentage

0%

Rate Quiz