CCNP Whole (1) 251

ccnp-whole-1-251

Exit

Question 1 of 1

Time Left

560781

block

What is the result of setting GLBP weighting at 105 with lower threshold 90 and upper threshold 100 on this router?

Select the correct answer(s).

(0/0)

560782

none

Which describes the default load balacing scheme used by the Gateway Load Balancing Protocol (GLBP)?

Select the correct answer(s).

(0/0)

560783

none

BPDUGuard is enabled on both ports of SwitchA. Initially, LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements about the possible result of attaching the second link are true? (Choose two.)

Select the correct answer(s).

(0/0)

560784

none

Which protocol will enable a group of routers to form a single virtual router and will use the real IP address of a router as the gateway address?

Select the correct answer(s).

(0/0)

560785

none

What two things occur when an RSTP edge port receives a BPDU? (Choose two.)

Select the correct answer(s).

(0/0)

560786

none

How does VTP pruning enhance network bandwidth?

Select the correct answer(s).

(0/0)

560787

none

In the hardware address 0000.0c07.ac0a, what does 07.ac represent?

Select the correct answer(s).

(0/0)

560788

none

If a switch stack is configured to use SDM templates, where are the templates stored

Select the correct answer(s).

(0/0)

560789

none

Which protocol specified by RFC 2281 provides network redundancy for IP networks, ensuring that user traffic immediately and transparently recovers from first-hop failures in network edge devices or access circuits?

Select the correct answer(s).

(0/0)

560790

none

HSRP was implemented and configured on two switches while scheduled network maintenance was performed. After the two switches have finished rebooting, you notice via show commands that Switch2 is the HSRP active router. Which two items are most likely the cause of Switch1 not becoming the active router? (Choose two)

Select the correct answer(s).

(0/0)

560791

none

Refer to the exhibit. Three switches are configured for HSRP. Switch1 remains in the HSRP listen state. What is the most likely cause of this status

Select the correct answer(s).

(0/0)

560792

none

What are three possible router states of HSRP routers on a LAN? (Choose three)

Select the correct answer(s).

(0/0)

560793

none

Refer to the exhibit. Which configuration on the HSRP neighboring device ensures that it becomes the active HSRP device in the event that port fa1/1 on Switch_A goes down?

Select the correct answer(s).

(0/0)

560822

none

HSRP has been configured between two Company devices. Which of the following describe reasons for deploying HSRP? (Choose three)

Select the correct answer(s).

(0/0)

560823

none

CCNP Whole (1) 251

Question 1 of 1

Time Left

What is the result of setting GLBP weighting at 105 with lower threshold 90 and upper threshold 100 on this router?

Select the correct answer(s).

(0/0)

Which describes the default load balacing scheme used by the Gateway Load Balancing Protocol (GLBP)?

Select the correct answer(s).

(0/0)

BPDUGuard is enabled on both ports of SwitchA. Initially, LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements about the possible result of attaching the second link are true? (Choose two.)

Select the correct answer(s).

(0/0)

Which protocol will enable a group of routers to form a single virtual router and will use the real IP address of a router as the gateway address?

Select the correct answer(s).

(0/0)

What two things occur when an RSTP edge port receives a BPDU? (Choose two.)

Select the correct answer(s).

(0/0)

How does VTP pruning enhance network bandwidth?

Select the correct answer(s).

(0/0)

In the hardware address 0000.0c07.ac0a, what does 07.ac represent?

Select the correct answer(s).

(0/0)

If a switch stack is configured to use SDM templates, where are the templates stored

Select the correct answer(s).

(0/0)

Which protocol specified by RFC 2281 provides network redundancy for IP networks, ensuring that user traffic immediately and transparently recovers from first-hop failures in network edge devices or access circuits?

Select the correct answer(s).

(0/0)

Select the correct answer(s).

(0/0)

Refer to the exhibit. Three switches are configured for HSRP. Switch1 remains in the HSRP listen state. What is the most likely cause of this status

Select the correct answer(s).

(0/0)

What are three possible router states of HSRP routers on a LAN? (Choose three)

Select the correct answer(s).

(0/0)

Refer to the exhibit. Which configuration on the HSRP neighboring device ensures that it becomes the active HSRP device in the event that port fa1/1 on Switch_A goes down?

Select the correct answer(s).

(0/0)

HSRP has been configured between two Company devices. Which of the following describe reasons for deploying HSRP? (Choose three)

Select the correct answer(s).

(0/0)

Regarding high availability, with the MAC address 0000.0c07.ac03, what does the “03” represent?

Select the correct answer(s).

(0/0)

Results

Correct

0

Incorrect

0

Skipped

0

Overall Percentage

0%

Rate Quiz