Any change in the state of the port generates a TC BDPU

Only edge ports moving to the blocking state generate a TC BPDU

ny loss of connectivity generates a TC BDPU

If either an edge port or a non-edge port move to a block state, then a TC BDPU is generated

Only non-edge ports moving to the forwarding state generate a TC BDPU

A monitor session on the distribution switch with a physical interface as the source and a physical interface as the destination

A monitor session on the distribution switch with a remote SPAN VLAN as the source and physical interface as the destination

A monitor session on the distribution switch with a physical interface as the source and the remote SPAN VLAN as the destination

A remote SPAN VLAN on the distribution and access layer switch

A monitor session on the access switch with a physical interface source and the remote SPAN VLAN as the destination D

A monitor session on the access switch with a remote SPAN VLAN source and the physical interface as the destination

600

300

100

180

access

VLAN

DHCP snooping

routing

port security

trunk

Create a Layer 3 transit VLAN to segment the traffic between the sites.

Configure manual trunk pruning between the two locations.

Use VTP pruning on the trunk interfaces.

Modify the spanning-tree priorities to dictate the traffic flow.

Only one RSPAN VLAN can be configured per device.

MAC address learning is not supported.

RSPAN VLANs can carry RSPAN traffic only.

RSPAN VLANs are exempt from VTP pruning.

PAN uses are GRE tunnel to transmit captured traffic.

It supports MAC address learning.

Only if both tracked objects are up will this router will be available as an AVF for group 1.

If the state of one tracked object goes down then this router will release its status as an AVF for group 1.

Only if the state of both tracked objects goes down will this router release its status as an AVF for group 1.

If both tracked objects go down and then one comes up, but the other remains down, this router will be available as an AVF for group 1.

This configuration is incorrect and will not have any effect on GLBP operation.

syslog

flat file

collector

another network device