Drift between adjacent stories should be limited to 0.0025 times the story height.

Maximum drift should be limited to 1/100 of a buildMaximum drift should be limited to ing's height.

Maximum drift should be limited to 1/500 of a building's height.

Drift between adjacent stories should be limited to 0.025 tiems the story height.

13 in

7.0 in

5.5 in

5.0 in

extra-long span suspension bridge

commercial building with a total height of 50 ft

building with a height-to-width ratio of 3

residential building with a height of 200 ft

building with a height-to-width ratio of 7

office building with a height of 450 ft

Exterior columns used with tilt-up walls must be precast concrete columns.

Tilt-up walls provide a good fire resistance, great strength, and low maintenance.

Tilt-up walls are delivered on a truck.

tilt-up walls are subject to high stresses during construction

Tilt-up walls can be supported by a structural steel frame

Tilt-up walls are reinforced concrete walls that are precast gfenerally in a flat position and later tilted up to a vertical position

a cantilever wall

a gravity wall

either a gravity or a counterfort wall

a counterfort wall

Heat pumps have a relatively low intitial cost.

Heat pumps use the refrigerator cycle to heat and cool

Air-to-air heat pumps are the most common types of pumps used for small buildings.

Heat pumps minimize operating costs in moderate climates.

Air-to-air heat pumps are appropriate for areas with cold winters.

Heat pumps can be connected to solar collectors and water storage tanks.

storage tank that is placed above the collector

low initial cost

high operation cost

reliable mechanical system

pump

storage tank that can cause structural costs

rebar layouts

pier reinforcing schedules

elevations for tops of beams and structural walls

footing details

5

4

3

2

site plans

construction documents

occupant load calculations

structural drawings

fire protection shop drawings

structural calculations

Epoxy-coated reinforcing steel bars are used only on interior concrete floor slabs

American bar numbers equal the number of eights of an inch across the diameter

American and metric sizes are now based on a unitless number

Reinforcing bars are available only in Grade 40

hardeners

chamfer strips

walers

rustication strips

sprinkler head location

luminary location

lighting and power outlet cicuiting

grille and register location

weep holes

base flashing

drips

coping